Skip to content
Shopping cart

Guide: How to find the right frame size for Gravel & Touring bikes

Choosing a frame size for Gravel and Touring is about finding the perfect balance between your body's anatomy and the bike's geometry. Whether you're building a bike from scratch or buying a complete model, the goal is a position that lets you ride mile after mile without unnecessary strain. In this guide, we'll explain how to calculate your theoretical size and fine-tune your choice based on stack and reach.

1. Calculate your theoretical frame or bike size

One of the most tried-and-tested ways to find a starting point for classic frames (measured center-to-top) is to use your inseam. It's easiest if you have a spirit level to measure with. Make sure you're not wearing shoes. Alternatively, stand perfectly upright with your back against a wall and hold a book against the wall to measure. The important thing is to keep it straight so the measurement is accurate.

The formula for road and touring:
Inseam in cm × 0.665 = Your frame size

Example: If your inseam is 84 cm, the calculation is 84 x 0.665 = 55.86. So your theoretical size is about 56 cm. For gravel, where a slightly more manageable bike is often preferred on technical terrain, round down.

2. Adjust for Stack & Reach

The formula gives you the frame height, but modern geometries vary greatly. To know how the bike will actually feel on long-distance rides, we need to look at:

  • Stack (Height): Determines how upright you sit. For touring, you often want a higher stack to reduce strain on your back and neck.
  • Reach (Length): Determines how stretched out your upper body will be. A shorter reach combined with a suitably long stem often gives you the best control on gravel roads.

General guideline for adults

Height Inseam (approx.) Theoretical frame size Recommended size
165 – 172 cm 75 – 79 cm 50 – 52 cm Small / 50-52
172 – 180 cm 80 – 84 cm 53 – 55 cm Medium / 54
180 – 188 cm 85 – 88 cm 56 – 58 cm Large / 56-58
188 – 195 cm 89 – 93 cm 59 – 63 cm X-Large / 60-63

Are you between sizes?

This is a classic situation for many cyclists. The following logic applies to touring and gravel:

Size up if:

You want a more stable bike for heavy loads and a more upright riding position without needing an extreme number of spacers.

Size down if:

You want a more nimble bike for technical trails and prefer a slightly more aggressive (lower) position.

We'll help you with the geometry

Calculating a size is a good starting point, but nothing beats comparing actual geometry charts. If you're unsure, contact us and we'll be happy to help.